Foundry Networks Switch and Router Installation And Configuration Manual page 650

Switch and router
Table of Contents

Advertisement

Foundry Switch and Router Installation and Configuration Guide
This display shows the following information.
This Field...
RP
Info source
USING THE WEB MANAGEMENT INTERFACE
You cannot display PIM Sparse information using the Web management interface.
Displaying the RP Set List
To display the RP set list, use the following CLI method.
USING THE CLI
To display the RP set list, enter the following command at any CLI level:
BigIron(config-pim-router)# show ip pim rp-set
Number of group prefixes = 1
Group prefix = 224.0.0.0/4
RP 1: 207.95.7.1
Syntax: show ip pim rp-set
This display shows the following information.
This Field...
Number of group prefixes
Group prefix
RPs expected/received
RP <num>
priority
age
USING THE WEB MANAGEMENT INTERFACE
You cannot display PIM Sparse information using the Web management interface.
18 - 24
Displays...
Indicates the IP address of the Rendezvous Point (RP) for the
specified PIM Sparse group.
Following the IP address is the port or virtual interface through which
this Layer 3 Switch learned the identity of the RP.
Indicates the IP address on which the RP information was received.
Following the IP address is the method through which this Layer 3
Switch learned the identity of the RP.
# RPs expected/received: 1
priority=0
age=0
Displays...
The number f PIM Sparse group prefixes for which the RP is
responsible.
Indicates the multicast groups for which the RP listed by the previous
field is a candidate RP.
Indicates how many RPs were expected and received in the latest
Bootstrap message.
Indicates the RP number. If there are multiple RPs in the PIM Sparse
domain, a line of information for each of them is listed, and they are
numbered in ascending numerical order.
The RP priority of the candidate RP. During the election process, the
candidate RP with the highest priority is elected as the RP.
The age (in seconds) of this RP-set.
Note: If this Layer 3 Switch is not a BSR, this field contains zero. Only
the BSR ages the RP-set.
December 2000

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents