Foundry Networks Switch and Router Installation And Configuration Manual page 940

Foundry Switch and Router Installation and Configuration Guide
Syntax: [no] spanning-tree
Syntax: spanning-tree [ethernet <portnum> path-cost <value> priority <value>] forward-delay <value>
hello-time <value> maximum-age <time> priority <value>
Modifying a Port-Based VLAN
You can make the following modifications to a port-based VLAN:
• Add or delete a VLAN port.
• Change its priority.
• Enable or disable STP.
Removing a Port-Based VLAN
Suppose you want to remove VLAN 5 from the example in Figure 25.12. To do so, use the following procedure.
USING THE CLI
1. Access the global CONFIG level of the CLI on FastIron-A by entering the following commands:
FastIron-A> enable
No password has been assigned yet...
FastIron-A# configure terminal
FastIron-A(config)#
2. Enter the following command:
FastIron-A(config)# no vlan 5
FastIron-A(config)#
3. Enter the following commands to exit the CONFIG level and save the configuration to the system-config file on
flash memory:
FastIron-A(config)#
FastIron-A(config)# end
FastIron-A# write memory
FastIron-A#
4. Repeat steps 1 – 3 on FastIron-B.
Syntax: no vlan <vlan-id> by port
Removing a Port from a VLAN
Suppose you want to remove port 11 from VLAN 4 on FastIron-A shown in Figure 25.12. To do so, use the
following procedure.
USING THE CLI
1. Access the global CONFIG level of the CLI on FastIron-A by entering the following command:
FastIron-A> enable
No password has been assigned yet...
FastIron-A# configure terminal
FastIron-A(config)#
2. Access the level of the CLI for configuring port-based VLAN 4 by entering the following command:
FastIron-A(config)#
FastIron-A(config)# vlan 4
FastIron-A(config-vlan-4)#
25 - 20 December 2000