Displaying Ospf Information; Displaying General Ospf Configuration Information - Foundry Networks Switch and Router Installation And Configuration Manual

7. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.

Displaying OSPF Information

You can use CLI commands and Web management options to display the following OSPF information:
• Trap, area, and interface information – see "Displaying General OSPF Configuration Information" on page 17-
41.
• CPU utilization statistics – see "Displaying CPU Utilization Statistics" on page 17-42.
• Area information – see "Displaying OSPF Area Information" on page 17-43.
• Neighbor information – see "Displaying OSPF Neighbor Information" on page 17-44.
• Interface information – see "Displaying OSPF Interface Information" on page 17-46.
• Route information – see "Displaying OSPF Route Information" on page 17-46.
• External link state information – see "Displaying OSPF External Link State Information" on page 17-48.
• Link state information – see "Displaying OSPF Link State Information" on page 17-49.
• Virtual Neighbor information – see "Displaying OSPF Virtual Neighbor Information" on page 17-50.
• Virtual Link information – see "Displaying OSPF Virtual Link Information" on page 17-50.
• ABR and ASBR information – see "Displaying OSPF ABR and ASBR Information" on page 17-51.
• Trap state information – see "Displaying OSPF Trap Status" on page 17-51.

Displaying General OSPF Configuration Information

To display general OSPF configuration information, enter the following command at any CLI level:
BigIron> show ip ospf config
Router OSPF: Enabled
Redistribution: Disabled
Default OSPF Metric: 10
OSPF Redistribution Metric: Type2
OSPF External LSA Limit: 25000
OSPF Database Overflow Interval: 0
RFC 1583 Compatibility: Enabled
Router id: 207.95.11.128
Interface State Change Trap:
Virtual Interface State Change Trap:
Neighbor State Change Trap:
Virtual Neighbor State Change Trap:
Interface Configuration Error Trap:
Virtual Interface Configuration Error Trap:
Interface Authentication Failure Trap:
Virtual Interface Authentication Failure Trap:
Interface Receive Bad Packet Trap:
Virtual Interface Receive Bad Packet Trap:
Interface Retransmit Packet Trap:
Virtual Interface Retransmit Packet Trap:
December 2000
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Configuring OSPF
17 - 41