Foundry Networks Switch and Router Installation And Configuration Manual page 214

Foundry Switch and Router Installation and Configuration Guide
Feature
AppleTalk routing
AppleTalk zone and network filters
IP Multicast Routing (PIM and DVMRP)
IP/RIP and IP/OSPF redistribution filters
User Datagram Protocol (UDP) Helper
Layer 4 Switching Features
Session switching
TCP/UDP access policies
Layer 4 Caching Features
Transparent Cache Switching (TCS)
TCS filters
Load Balancing and Redundancy Features
Server Load Balancing (SLB)
Router support for Globally-distributed SLB
Firewall Load Balancing
Virtual Router Redundancy Protocol (VRRP)
Foundry Server Redundancy Protocol (FSRP)
Layer 4 switch redundancy
a.Router acceleration is supported only on the FastIron Backbone switch and TurboIron Backbone switch.
b.A ServerIron feature available as an optional upgrade for Layer 2 Switches.
c.This feature can be used with Foundry ServerIron switches, third-party SLBs, and directly-connected web
servers.
Showing System Defaults
You can display the defaults for system parameters using either of the following methods.
USING THE CLI
To display the default information, enter the following command from any level of the CLI:
show default [values]
If you specify "default" but not the optional "values", the default states for parameters that can either be enabled or
disabled are displayed. If you also specify "values", the default values and configurable ranges for various tables
are displayed.
Here is an example of the information displayed by the show default command on a BigIron Layer 3 Switch.
BigIron# show default
spanning tree disabled
8 - 6
Table 8.2: Foundry Software Features (Continued)
c
Supported on...
Router Switch SrvrIrn
X
X
X
X
X
X X
X X X
b X
X
b X
X
b X
X
X
X
X
X
b X
X
See page...
8-23
8-24
8-24
8-24
8-24
8-25
8-25
8-25
8-25
8-26
8-26
8-26
8-26
8-27
8-27
December 2000