Table of Contents
Advertisement
Foundry Switch and Router Installation and Configuration Guide
USING THE WEB MANAGEMENT INTERFACE
1.
Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2.
Click on the plus sign next to Monitor in the tree view to display the monitoring options.
3.
Select the Device link to display the following panel.
The temperature is listed in the Temperature field. The temperature information is color coded to indicate the
state.
•
Green indicates the temperature is within the normal operating range.
•
Orange indicates the temperature has reached the warning level.
•
Red indicates the temperature has reached the shutdown level.
NOTE: You also can display the Device Information panel by clicking on the graphic of the chassis panel, in the
upper right frame. The graphic is shown only if the Web management interface frames are enabled.
Displaying Temperature Messages
The software sends a Syslog message and an SNMP trap if the temperature crosses the warning or shutdown
thresholds. The following methods describe how to view the system log on the device. If you have configured the
device to use a SyslogD server or SNMP trap receiver, see the documentation for the server or receiver.
USING THE CLI
To display the system log, enter the following command at any CLI level:
BigIron# show log
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 8 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
5 - 34
December 2000
- Quick Links:
- Configuring Ip Addresses
Hide quick links:
Advertisement
Chapters
Table of Contents
