Foundry Networks Switch and Router Installation And Configuration Manual page 210

Foundry Switch and Router Installation and Configuration Guide
Flash Images
The flash image (system software) that is running on a device determines the software features that are supported
by that device. Table 8.1 on page 8-2 lists the flash images that can be used on each Foundry device.
Product
NetIron Internet Backbone router
BigIron
FastIron II
FastIron II Plus
TurboIron/8
FastIron Workgroup
NetIron (Stackable device)
ServerIron 400
ServerIron 800
ServerIronXL (8-, 16-, and 24-port
models)
ServerIronXL/TCS
ServerIronXL/G
Notice that some devices can run either switch code or router code. For these devices, one type of code is always
installed at the factory by default. These devices can be reconfigured to run the other code by installing the
software and, in some cases, installing a firmware upgrade. Contact Foundry Networks or your reseller for details.
NOTE: Some features are supported only on specific products or require specific hardware configurations. See
the chapters describing those features or contact Foundry Networks or your reseller for information.
8 - 2
Table 8.1: Foundry Flash Software Images
Flash image
BIRxxxxx.BIN
B2Rxxxxx.BIN (redundant
management module)
BIPxxxxx.BIN
B2Pxxxxx.BIN (redundant
management module)
BISxxxxx.BIN
B2Sxxxxx.BIN (redundant
management module)
BBRxxxxx.bin
P2Rxxxxx.BIN
FWSxxxxx.BIN
NBRxxxxx.bin
N8Rxxxxx.BIN
WSMxxxxx.bin (management
processor code)
WSPxxxxx.bin (web switching
CPU code)
SLBxxxxx.BIN
BSIxxxxx.BIN
Description
Router code
IP-only router code
Switch code
Switch code with basic Layer 3
support
POS code
Note: Requires Management II or
higher
Switch code
Switch code with basic Layer 3
support
Router code for Chassis devices
with three LEDs per port
ServerIron 400/800 code
Stackable ServerIron code
Note: For the ServerIronXL/TCS,
only the system-level features,
Layer 2 features, and TCS are
supported.
Stackable ServerIron code
December 2000