Foundry Networks Switch and Router Installation And Configuration Manual page 572

Foundry Switch and Router Installation and Configuration Guide
USING THE WEB MANAGEMENT INTERFACE
To display RIP filter information:
1. Log on to the device using a valid user name and password for read-only or read-write access. The System
configuration panel is displayed.
2. Click on the plus sign next to Configure in the tree view.
3. Click on the plus sign next to RIP.
4. Select one of the following links:
• Neighbor Filter
• Route Filter
• Redistribution Filter
Displaying CPU Utilization Statistics
You can display CPU utilization statistics for RIP and other IP protocols.
USING THE CLI
To display CPU utilization statistics for RIP for the previous one-second, one-minute, five-minute, and fifteen-
minute intervals, enter the following command at any level of the CLI:
BigIron# show process cpu
Process Name 5Sec(%)
ARP
BGP
ICMP
IP
OSPF
RIP
STP
VRRP
If the software has been running less than 15 minutes (the maximum interval for utilization statistics), the
command indicates how long the software has been running. Here is an example:
BigIron# show process cpu
The system has only been up for 6 seconds.
Process Name 5Sec(%)
ARP
BGP
ICMP
IP
OSPF
RIP
STP
VRRP
To display utilization statistics for a specific number of seconds, enter a command such as the following:
BigIron# show process cpu 1
Process Name Sec(%)
ARP
BGP
ICMP
IP
OSPF
RIP
16 - 18
1Min(%) 5Min(%)
0.01 0.03
0.04 0.06
0.00 0.00
0.00 0.00
0.00 0.00
0.04 0.07
0.00 0.00
0.00 0.00
1Min(%) 5Min(%)
0.01 0.00
0.00 0.00
0.01 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
Time(ms)
0.00 0
0.00 0
0.01 1
0.00 0
0.00 0
0.00 0
15Min(%) Runtime(ms)
0.09 0.22
0.08 0.14
0.00 0.00
0.00 0.00
0.00 0.00
0.08 0.09
0.00 0.00
0.00 0.00
15Min(%) Runtime(ms)
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
0.00 0.00
9
13
0
0
0
7
0
0
0
0
1
0
0
0
0
0
December 2000