Foundry Networks Switch and Router Installation And Configuration Manual page 759

14. Enter the name of the route map in the Route Map Name field.
15. Enter the sequence (instance) number in the Sequence field. The Layer 3 Switch applies the instances in
ascending numerical order. Once an instance comparison results in a "true" evaluation, the Layer 3 Switch
stops applying instances and applies the match and set statements you configure for the instance.
NOTE: In this example, the sequence number matches the address filter number. Using the same number
is a convenient way to remember that these configuration items are associated, but is not a requirement.
16. Select the action you want the Layer 3 Switch to perform if the comparison results in a "true" value:
• If you select Deny, the Layer 3 Switch does not advertise or learn the route.
• If you select Permit, the Layer 3 Switch applies the match and set statements associated with this route
map instance.
17. Click the Add button to apply the changes to the device's running-config file.
18. Select the Route Map Match link at the bottom of the panel to display the BGP Route Map Match panel, as
shown in the following example.
December 2000
Configuring BGP4
19 - 77