Foundry Networks Switch and Router Installation And Configuration Manual page 860

Foundry Switch and Router Installation and Configuration Guide
5. Select the interface from the pulldown list on the Port field. In this example, select 1/6.
6. Enter the VRID in the Router ID field the Router ID field. In this example, use the default value, 1.
7. Enter the Hello interval or leave the field unchanged to use the default. The software fills in the default after
you select Add. In this example, leave the field unchanged.
8. Select Enable to activate the VRRP entry after you select Add.
9. Enter the interface's IP address in the IP Address List field. In this example, enter 192.53.5.1.
10. Select the mode (Owner or Backup). Select Owner in this example.
11. Enter the track priority or leave the field blank to use the default. In this example, enter 20.
12. Enter or select the track interface or port:
• If you want to use a virtual interface as a track port, enter the virtual interface name.
• If you want to use a physical interface as a track port, select the port. In this example, select 2/4.
13. Click the Add button to apply the changes to the device's running-config.
14. Select the Save link at the bottom of the dialog, then select Yes when prompted to save the configuration
change to the startup-config file on the device's flash memory.
21 - 34 December 2000