Foundry Networks Switch and Router Installation And Configuration Manual page 644

Foundry Switch and Router Installation and Configuration Guide
The <num> parameter specifies the number of seconds and can from 1 – 65535. The default is 60.
USING THE WEB MANAGEMENT INTERFACE
You cannot configure PIM Sparse parameters using the Web management interface.
Displaying PIM Sparse Configuration Information and Statistics
You can display the following PIM Sparse information:
• Basic PIM Sparse configuration information
• Group information
• BSR information
• Candidate RP information
• RP-to-group mappings
• RP information for a PIM Sparse group
• RP set list
• PIM Neighbor information
• The PIM flow cache
• The PIM multicast cache
• PIM traffic statistics
Displaying Basic PIM Sparse Configuration Information
To display basic configuration information for PIM Sparse, use the following CLI method.
USING THE CLI
To display PIM Sparse configuration information, enter the following command at any CLI level:
BigIron(config-pim-router)# show ip pim sparse
Global PIM Sparse Mode Settings
Hello interval: 60, Neighbor timeout: 180
Bootstrap Msg interval: 130, Candidate-RP Advertisement interval: 60
Join/Prune interval: 60, SPT Threshold: 1
Interface Ethernet e3/8
TTL Threshold: 1, Enabled
Local Address: 207.95.8.1
Interface Ve 1
TTL Threshold: 1, Enabled
Local Address: 207.95.6.1
Syntax: show ip pim sparse
This example shows the PIM Sparse configuration information on PIM Sparse router A in Figure 18.3.
18 - 18 December 2000