Foundry Networks Switch and Router Installation And Configuration Manual page 419

Using Access Control Lists (ACLs)
The following command enables PBR by globally applying the route map to all interfaces.
BigIron(config)# ip policy route-map file-13
Alternatively, you can enable the PBR on specific interfaces, as shown in the following example. The commands
in this example configure IP addresses in the source sub-net identified in ACL 6, then apply route map file-13 to
the interface.
BigIron(config)# interface ethernet 3/11
BigIron(config-if-3/11)# ip address 192.168.1.204/32
BigIron(config-if-3/11)# ip policy route-map file-13
December 2000 13 - 31