Foundry Networks Switch and Router Installation And Configuration Manual page 892

Foundry Switch and Router Installation and Configuration Guide
This display shows the following information.
This Field...
Interface
MAC address
Port state
IPX network
Frame type
Allow NetBIOS
rip-interval
rip-max-packet-size
rip-multiplier
sap-interval
23 - 18
Table 23.2: CLI Display of IPX Interface Information
Displays...
The port or virtual interface on which the IPX interface is configured.
The MAC address of the interface.
The state of the interface. The state can be one of the following:
• DOWN
• UP
The IPX network number.
The frame type of the network. The frame type can be one of the
following:
• ethernet_802.2
• ethernet_802.3
• ethernet_ii
• ethernet_snap
Indicates whether the interface allows NetBIOS traffic. This field can
have the following values:
• NO
• YES
The RIP advertisement interval. The RIP advertisement interval
specifies how often the Layer 3 Switch sends IPX RIP updates to
neighboring IPX routers.
To modify this parameter, see "Modify the RIP Advertisement Interval"
on page 23-14.
The maximum packet size for IPX RIP updates. The default IPX RIP
packet size is 432 bytes, which allows 50 routes plus 32 bytes of
header in an IPX RIP update packet.
To modify this parameter, see "Modify the RIP Advertisement Packet
Size" on page 23-13.
The age timer for learned IPX routes. The age timer specifies how
many seconds a learned IPX route can remain in the Layer 3 Switch's
IPX route table before aging out.
To modify this parameter, see "Modify the Age Timer for Learned IPX
Routes" on page 23-15.
The SAP advertisement interval. The IPX SAP advertisement interval
specifies how often the Layer 3 Switch sends IPX SAP updates to
neighboring IPX routers.
To modify this parameter, see "Modify the SAP Advertisement
Interval" on page 23-14.
December 2000