Displaying Ospf Area Information - Foundry Networks Switch and Router Installation And Configuration Manual

RIP
STP
VRRP
To display utilization statistics for a specific number of seconds, enter a command such as the following:
BigIron# show process cpu 1
Process Name Sec(%)
ARP
BGP
ICMP
IP
OSPF
RIP
STP
VRRP
Syntax: show process cpu [<num>]
The <num> parameter specifies the number of seconds and can be from 1 – 900. If you use this parameter, the
command lists the usage statistics only for the specified number of seconds. If you do not use this parameter, the
command lists the usage statistics for the previous one-second, one-minute, five-minute, and fifteen-minute
intervals.
USING THE WEB MANAGEMENT INTERFACE
You cannot display this information using the Web management interface.

Displaying OSPF Area Information

To display global OSPF area information for the router, use one of the following methods.
USING THE CLI
To display OSPF area information, enter the following command at any CLI level:
BigIron> show ip ospf area
Indx Area
1 0.0.0.0
2 192.147.60.0 normal
3 192.147.80.0 stub
Syntax: show ip ospf area [<area-id>] | [<num>]
The <area-id> parameter shows information for the specified area.
The <num> parameter displays the entry that corresponds to the entry number you enter. The entry number
identifies the entry's position in the area table.
This display shows the following information.
This Field...
Indx
Area
Type
December 2000
0.00 0.00
0.00 0.00
0.00 0.00
Time(ms)
0.00 0
0.00 0
0.01 1
0.00 0
0.00 0
0.00 0
0.00 0
0.00 0
Type Cost SPFR ABR ASBR LSA Chksum(Hex)
normal 0 1 0
0 1 0
1 1 0
Table 17.2: CLI Display of OSPF Area Information
Displays...
The row number of the entry in the router's OSPF area table.
The area number.
The area type, which can be one of the following:
•
•
•
0.00 0.00
0.00 0.00
0.00 0.00
0 1 0000781f
0 1 0000fee6
0 2 000181cd
nssa
normal
stub
Configuring OSPF
0
0
0
17 - 43