Foundry Networks Switch and Router Installation And Configuration Manual page 329

• IPX forwarding filters
• AppleTalk routes
• AppleTalk zones
The tables you can configure and the defaults and valid ranges for each table differ depending on the Foundry
device you are configuring.
NOTE: If you increase the number of sub-net addresses you can configure on each port to a higher amount, you
might also need to increase the total number of sub-nets that you can configure on the device.
To display and configure the adjustable tables on a device, use one of the following methods.
NOTE: Changing the table size for a parameter reconfigures the device's memory. Whenever you reconfigure
the memory on a Foundry device, you must save the change to the startup-config file, then reload the software to
place the change into effect.
USING THE CLI
To display the configurable tables and their defaults and maximum values, enter the following command at any
level of the CLI:
BigIron# show default values
sys log buffers:50
ip arp age:10 min
ip addr per intf:24
when multicast enabled :
igmp group memb.:140 sec
when ospf enabled :
ospf dead:40 sec
ospf transit delay:1 sec
when bgp enabled :
bgp local pref.:100
bgp metric:10
bgp ext. distance:20
System Parameters
ip-arp
ip-static-arp
atalk-route
atalk-zone-port
atalk-zone-sys
dvmrp
igmp
ip-cache
ip-filter-port
ip-filter-sys
ipx-forward-filter
ipx-rip-entry
ipx-rip-filter
ipx-sap-entry
ipx-sap-filter
l3-vlan
ip-qos-session
December 2000
mac age time:300 sec
bootp relay max hops:4
igmp query:60 sec
ospf hello:10 sec
bgp keep alive:60 sec
bgp local as:1
bgp int. distance:200
Default Maximum
8000 64000
1024 2048
512 1536
64 255
255 1024
2048 32000
256 1024
128000 256000
512 4096
1024 8192
256 1024
3072 32728
256 1024
6144 32768
256 1024
32 2048
2048 32000
telnet sessions:5
ip ttl:64 hops
ospf retrans:5 sec
bgp hold:180 sec
bgp cluster id:0
bgp local distance:200
Current
8000
1024
512
64
255
2048
256
128000
512
1024
256
3072
256
6144
256
32
2048
Configuring Basic Features
10 - 71