NOTE: If you decrease the size of the buffer, the software clears the buffer before placing the change into effect.
If you increase the size of the buffer, the software does not clear existing entries.
Changing the Log Facility
The SyslogD daemon on the SyslogD server uses a facility to determine where to log the messages from the
Foundry device. The default facility for messages the Foundry device sends to the SyslogD server is "user". You
can change the facility using the following command.
NOTE: You can specify only one facility. If you configure the Foundry device to use two SyslogD servers, the
device uses the same facility on both servers.
BigIron(config)# logging facility local0
Syntax: logging facility <facility-name>
The <facility-name> can be one of the following:
•
kern – kernel messages
•
user – random user-level messages
•
mail – mail system
•
daemon – system daemons
•
auth – security/authorization messages
•
syslog – messages generated internally by syslogd
•
lpr – line printer subsystem
•
news – netnews subsystem
•
uucp – uucp subsystem
•
sys9 – cron/at subsystem
•
sys10 – reserved for system use
•
sys11 – reserved for system use
•
sys12 – reserved for system use
•
sys13 – reserved for system use
•
sys14 – reserved for system use
•
cron – cron/at subsystem
•
local0 – reserved for local use
•
local1 – reserved for local use
•
local2 – reserved for local use
•
local3 – reserved for local use
•
local4 – reserved for local use
•
local5 – reserved for local use
•
local6 – reserved for local use
•
local7 – reserved for local use
Displaying the Syslog Configuration
To display the Syslog parameters currently in effect on a Foundry device, enter the following command from any
level of the CLI:
December 2000
Configuring Basic Features
10 - 17