Foundry Networks Switch and Router Installation And Configuration Manual page 654

Foundry Switch and Router Installation and Configuration Guide
This Field...
prune ports
virtual prune ports
USING THE WEB MANAGEMENT INTERFACE
You cannot display the PIM multicast cache using the Web management interface.
Displaying PIM Traffic Statistics
To display PIM traffic statistics, use the following CLI method.
USING THE CLI
To display PIM traffic statistics, enter the following command at any CLI level:
BigIron(config-pim-router)# show ip pim traffic
Port Hello
[Rx Tx]
e3/8 19 19
Port Hello
[Rx Tx]
v1 18 19
Port Hello
[Rx Tx]
v2 0 19
Total 37 57
IGMP Statistics:
Total Recv/Xmit 85/110
Total Discard/chksum
Syntax: show ip pim traffic
NOTE: If you have configured interfaces for standard PIM (dense mode) on the Layer 3 Switch, statistics for
these interfaces are listed first by the display.
This display shows the following information.
This Field...
Port
Hello
J/P
Register
18 - 28
Displays...
Indicates the physical ports on which the Layer 3 Switch has received
a prune notification (in a Join/Prune message) to remove the receiver
from the list of recipients for the group.
Indicates the virtual interfaces ports on which the Layer 3 Switch has
received a prune notification (in a Join/Prune message) to remove the
receiver from the list of recipients for the group.
J/P Register
[Rx Tx] [Rx
32 0 0
J/P Register
[Rx Tx] [Rx
0 20 0
J/P Register
[Rx Tx] [Rx
0 0 0
32 0 0
0/0
Displays...
The port or virtual interface on which the PIM interface is configured.
The number of PIM Hello messages sent or received on the interface.
The number of Join/Prune messages sent or received on the
interface.
Note: Unlike PIM dense, PIM Sparse uses the same messages for
Joins and Prunes.
The number of Register messages sent or received on the interface.
RegStop
Tx] [Rx Tx]
0 37 0
RegStop
Tx] [Rx Tx]
0 0 0
RegStop
Tx] [Rx Tx]
16 0 0
0 0 0
Assert
[Rx Tx]
0 0
Assert
[Rx Tx]
0 0
Assert
[Rx Tx]
0 0
0 0
December 2000