Foundry Networks Switch and Router Installation And Configuration Manual page 621

Table 17.4: CLI Display of OSPF Route Information (Continued)
This Field...
Type2_Cost
Path_Type
Adv_Router
Link-State
Dest_Type
State
Tag
Flags
Paths
Out_Port
Next_Hop
Type
Arp_Index
State
December 2000
Displays...
The type 2 cost of this path.
The type of path, which can be one of the following:
• Inter – The path to the destination passes into another area.
• Intra – The path to the destination is entirely within the local
area.
• External1 – The path to the destination is a type 1 external
route.
• External2 – The path to the destination is a type 2 external
route.
The OSPF router that advertised the route to this Foundry Layer 3
Switch.
The link state from which the route was calculated.
The destination type, which can be one of the following:
• ABR – Area Border Router
• ASBR – Autonomous System Boundary Router
• Network – the network
The route state, which can be one of the following:
• Changed
• Invalid
• Valid
This information is used by Foundry technical support.
The external route tag.
State information for the route entry. This information is used by
Foundry technical support.
The number of paths to the destination.
The router port through which the Layer 3 Switch reaches the next
hop for this route path.
The IP address of the next-hop router for this path.
The route type, which can be one of the following:
• OSPF
• Static Replaced by OSPF
The index position in the ARP table of the ARP entry for this path's IP
address.
State information for the path. This information is used by Foundry
technical support.
Configuring OSPF
17 - 47