Displaying Detailed Information - Foundry Networks Switch and Router Installation And Configuration Manual

Table 21.2: CLI Display of VRRP or VRRPE Summary Information (Continued)
This Field...
State
Master addr
Backup addr
VIP
USING THE WEB MANAGEMENT INTERFACE
You cannot display the summary view using the Web management interface. Use the Web management
procedure in "Displaying Detailed Information".

Displaying Detailed Information

To display detailed VRRP or VRRPE information, use either of the following methods.
USING THE CLI
To display detailed information for a Layer 3 Switch, enter the following command at any level of the CLI:
BigIron Router(config)# show ip vrrp
Total number of VRRP routers defined: 1
Interface ethernet 1/6
auth-type no authentication
VRID 1
state master
administrative-status enabled
mode owner
priority 255
current priority 255
hello-interval 1 sec
advertise backup: disabled
track-port 2/4
This example is for a VRRP Owner. Here is an example for a VRRP Backup.
BigIron Router(config)# show ip vrrp
Total number of VRRP routers defined: 1
Interface ethernet 1/5
auth-type no authentication
December 2000
Displays...
This Layer 3 Switch's VRRP or VRRPE state for the VRID. The state
can be one of the following:
• Init – The VRID is not enabled (activated). If the state remains
Init after you activate the VRID, make sure that the VRID is also
configured on the other routers and that the routers can
communicate with each other.
Note: If the state is Init and the mode is incomplete, make sure
you have specified the IP address for the VRID.
• Backup – This Layer 3 Switch is a Backup for the VRID.
• Master – This Layer 3 Switch is the Master for the VRID.
The IP address of the router interface that is currently the Master for
the VRID.
The IP addresses of the router interfaces that are currently Backups
for the VRID.
The virtual IP address that is being backed up by the VRID.
Configuring VRRP and VRRPE
21 - 21