Foundry Switch and Router Installation and Configuration Guide
000000d0: 7420330a 69702061 64647265 73732031
000000e0: 39322e31 36382e32 2e353820 3235352e
000000f0: 3235352e 3235352e 300a656e
Syntax: hd [slot1 | slot2] <file-name>
Each row of hexadecimal output contains the following parts:
•
The byte offset of the date that is displayed to the right of the offset
•
A row of hexadecimal data
•
The ASCII equivalent of the hexadecimal data shown in the row
Creating a Subdirectory
To create a subdirectory on a flash card, enter a command such as the following:
BigIron# mkdir slot1 \TEST
To verify successful creation of the subdirectory, enter a command to change to the new subdirectory level:
BigIron# chdir \TEST
Current directory of slot1 is: \TEST
Syntax: md | mkdir [slot1 | slot2] <dir-name>
You can enter either md or mkdir for the command name.
The slot1 | slot2 parameter specifies a PCMCIA slot. If you do not specify a slot, the command applies to the slot
that currently has the management focus.
The <dir-name> parameter specifies the subdirectory name. You can enter a name that contains any combination
of the following characters. Do not enter a backslash " / " in front of the name.
•
All upper and lowercase letters
•
All digits
•
Spaces
•
Any of the following special characters:
•
$
•
%
•
'
•
-
•
_
•
@
•
~
•
`
•
!
•
(
•
)
•
{
•
}
•
^
•
#
•
&
5 - 24
t 3 ip address 1
92.168.2.58 255.
255.255.0 end
December 2000