Viewing System Information; Viewing Configuration Information - Foundry Networks Switch and Router Installation And Configuration Manual

BigIron(config)# rmon alarm 1 ifInOctets.6 10 delta rising-threshold 100 1 falling
threshold 50 1 owner nyc02
Syntax: rmon alarm <entry-number> <MIB-object.interface-num> <sampling-time> <sample-type>
<threshold-type> <threshold-value> <event-number> <threshold-type> <threshold-value> <event-number>
owner <text-string>
USING THE WEB MANAGEMENT INTERFACE
This display is not supported on the Web management interface.
Event (RMON Group 9)
There are two elements to the Event Group—the event control table and the event log table.
The event control table defines the action to be taken when an alarm is reported. Defined events can be found by
entering the CLI command, show event. The Event Log Table collects and stores reported events for retrieval by
an RMON application.
USING THE CLI
A sample entry and syntax of the event control table is shown below:
BigIron(config)# rmon event 1 description 'testing a longer string' log-and-trap
public owner nyc02
Syntax: rmon event <event-entry> description <text-string> log | trap | log-and-trap owner <rmon-station>
USING THE WEB MANAGEMENT INTERFACE
This display is not supported on the Web management interface.

Viewing System Information

You can access software and hardware specifics for a Foundry Layer 2 or Layer 3 Switch.
USING THE CLI
To view the software and hardware details for the system, enter the show version command:
BigIron# show version
Syntax: show version
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-only or read-write access. The System
configuration dialog is displayed.
2. Click on the plus sign next to Monitor in the tree view to expand the list of monitoring options.
3. Click on the Device link to display the Device Information panel.

Viewing Configuration Information

You can view a variety of configuration details and statistics with the show option. The show option provides a
convenient way to check configuration changes before saving them to flash.
The show options available will vary for switches and routers and by configuration level.
USING THE CLI
To determine the available show commands for the system or a specific level of the CLI, enter the following
command:
BigIron# show ?
Syntax: show <option>
December 2000
Network Monitoring
B - 3