Displaying Statistics - Foundry Networks Switch and Router Installation And Configuration Manual

Displaying Statistics

To display VRRP or VRRPE statistics, use either of the following methods.
USING THE CLI
To display statistics, enter a command such as the following at any level of the CLI:
BigIron Router(config-if-e1000-1/5-vrid-1)# show ip vrrp stat
Interface ethernet 1/5
rxed vrrp header error count = 0
rxed vrrp auth error count = 0
rxed vrrp auth passwd mismatch error count = 0
rxed vrrp vrid not found error count = 0
VRID 1
rxed arp packet drop count = 0
rxed ip packet drop count = 0
rxed vrrp port mismatch count = 0
rxed vrrp ip address mismatch count = 0
rxed vrrp hello interval mismatch count = 0
rxed vrrp priority zero from master count = 0
rxed vrrp higher priority count = 0
transitioned to master state count = 1
transitioned to backup state count = 1
The same statistics are listed for VRRP and VRRPE.
Syntax: show ip vrrp brief | ethernet <portnum> | ve <num> | stat
Syntax: show ip vrrp-extended brief | ethernet <portnum> | ve <num> | stat
The brief parameter displays summary information. See "Displaying Summary Information" on page 21-19.
The ethernet <portnum> parameter specifies an Ethernet port. If you use this parameter, the command displays
detailed VRRP or VRRPE information only for the specified port. See "Displaying Detailed Information" on
page 21-21.
The ve <num> parameter specifies a virtual interface. If you use this parameter, the command displays detailed
VRRP or VRRPE information only for the specified virtual interface. See "Displaying Detailed Information" on
page 21-21.
The stat parameter displays statistics. This parameter is required for displaying the statistics.
This display shows the following information.
This Field...
Interface Statistics
Interface
rxed vrrp header error count
rxed vrrp auth error count
rxed vrrp auth passwd mismatch error
count
December 2000
Table 21.5: CLI Display of VRRP or VRRPE Statistics
Displays...
The interface on which VRRP or VRRPE is configured. If VRRP or
VRRPE is configured on more than one interface, the display lists the
statistics separately for each interface.
The number of VRRP or VRRPE packets received by the interface
that had a header error.
The number of VRRP or VRRPE packets received by the interface
that had an authentication error.
The number of VRRP or VRRPE packets received by the interface
that had a password value that does not match the password used by
the interface for authentication.
Configuring VRRP and VRRPE
21 - 27