Dtc P0610[L3 With Tc] - Mazda CX-7 2007 Workshop Manual

STEP
3 VERIFY TROUBLESHOOTING OF P0607
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Clear the DTC from the PCM memory using
the M-MDS.
• Start engine.
• Is same DTC present?
4 VERIFY AFTER REPAIR PROCEDURE
• Perform the "After Repair Procedure".
(See01-02-10 AFTER REPAIR
PROCEDURE[L3 WITH TC].)
• Are any DTCs present?
End Of Sie

DTC P0610[L3 WITH TC]

DTC P0610 PCM vehicle options error
• PCM data configuration error
Diagnostic support note
• This is a continuous monitor (CCM).
DETECTION
• The MIL does not illuminate.
CONDITION
• FREEZE FRAME DATA is available.
• DTCs are stored in PCM memory.
• Configuration procedure has not been completed
POSSIBLE
• PCM malfunction
CAUSE
Diagnostic procedure
STEP
1 VERIFY FREEZE FRAME DATA HAS BEEN
RECORDED
• Has the FREEZE FRAME DATA been
recorded?
2 VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
• Check for related Service Bulletins and/or on-
line repair information availability.
• Is any related repair information available?
3 VERIFY TROUBLESHOOTING OF DTC P0610
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Turn the ignition switch to the ON position
(Engine off).
• Clear the DTC from the PCM memory using
the M-MDS.
• Start the engine.
• Is the same DTC present?
4 VERIFY AFTER REPAIR PROCEDURE
• Perform the "AFTER REPAIR PROCEDURE".
(See01-02-10 AFTER REPAIR
PROCEDURE[L3 WITH TC].)
• Are any DTCs present?
End Of Sie
ON-BOARD DIAGNOSTIC [L3 WITH TC]
INSPECTION
INSPECTION
Yes Replace PCM, go to the next step.
(See01-40-6 PCM REMOVAL/INSTALLATION[L3 WITH
TC].)
No Go to the next step.
Yes Go to the applicable DTC inspection.
(See01-02-13 DTC TABLE[L3 WITH TC].)
No Troubleshooting completed.
Yes Go to the next step.
No Record FREEZE FRAME DATA on the repair order, then go
to the next step.
Yes Perform the repair or diagnosis according to the available
repair information.
• If the vehicle is not repaired, go to the next step.
No Go to the next step.
Yes Replace the PCM, then go to the next step.
(See01-40-6 PCM REMOVAL/INSTALLATION[L3 WITH
TC].)
No Go to the next step.
Yes Go to the applicable DTC troubleshooting.
(See01-02-13 DTC TABLE[L3 WITH TC].)
No Troubleshooting completed.
ACTION
id010239809600
ACTION
01-02–173
01-02