Dtc P2119[L3 With Tc] - Mazda CX-7 2007 Workshop Manual

STEP
5 VERIFY INTERMITTENT MALFUNCTION AT TP
SENSOR NO.2 CIRCUIT
• Perform the INTERMITTENT
TROUBLESHOOTING procedure to TP sensor
No.2 related harnesses and connectors.
(See01-03-76 INTERMITTENT CONCERN
TROUBLESHOOTING[L3 WITH TC].)
• Is there any malfunction
6 INSPECT TP SENSOR
• Inspect the TP sensor.
• Is the TP sensor normal?
7 VERIFY TROUBLESHOOTING OF DTC P2108
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Clear the DTC from the PCM memory using
the M-MDS.
• Turn ignition switch to the ON position (Engine
off).
• Is the PENDING CODE for this DTC present?
8 VERIFY AFTER REPAIR PROCEDURE
• Perform the "After Repair Procedure".
(See01-02-10 AFTER REPAIR
PROCEDURE[L3 WITH TC].)
• Are any DTCs present?
End Of Sie

DTC P2119[L3 WITH TC]

DTC P2119 Throttle actuator control throttle body range/performance problem
• The PCM compares the TP with the default TP when the ignition switch is off. If the TP is higher than the
default TP, the PCM determines that there is a throttle actuator control throttle body range/performance
problem.
Diagnostic support note
DETECTION
• This is a continuous monitor (CCM).
CONDITION
• The MIL illuminates if the PCM detects the above malfunctioning condition in the first drive cycles.
• FREEZE FRAME DATA is available.
• DTCs are stored in the PCM memory.
• Throttle actuator malfunction
POSSIBLE
• Throttle valve malfunction
CAUSE
• PCM malfunction
Diagnostic procedure
STEP
1 VERIFY FREEZE FRAME DATA HAS BEEN
RECORDED
• Has the FREEZE FRAME DATA been
recorded?
2 VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
• Verify related Service Bulletins and/or on-line
repair information availability.
• Is any related repair information available?
3 INSPECT THROTTLE ACTUATOR
• Inspect the throttle actuator.
(See01-13-12 THROTTLE ACTUATOR
INSPECTION[L3 WITH TC].)
• Is there any malfunction?
4 INSPECT TP SENSOR
• Inspect the TP sensor.
(See01-13-12 THROTTLE ACTUATOR
INSPECTION[L3 WITH TC].)
• Is there any malfunction?
ON-BOARD DIAGNOSTIC [L3 WITH TC]
INSPECTION
INSPECTION
Yes Repair or replace malfunctioning part, according to
inspection result, the go to Step 7.
No Go to the next step.
Yes Go to the next step.
No Replace the throttle body, then go to nest step.
Yes Replace the PCM, then go to the next step.
(See01-40-6 PCM REMOVAL/INSTALLATION[L3 WITH
TC].)
No Go to the next step.
Yes Go to the applicable DTC inspection.
(See01-02-13 DTC TABLE[L3 WITH TC].)
No Troubleshooting completed.
Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order,
then go to the next step.
Yes Perform the repair or diagnosis according to the available
repair information.
• If the vehicle is not repaired, go to the next step.
No Go to the next step.
Yes Replace the throttle body, then go to Step 5.
(See01-13-5 INTAKE AIR SYSTEM REMOVAL/
INSTALLATION[L3 WITH TC].)
No Go to the next step.
Yes Replace the TP sensor, then go to the next step.
(See01-13-5 INTAKE AIR SYSTEM REMOVAL/
INSTALLATION[L3 WITH TC].)
No Go to the next step.
ACTION
id010239811600
ACTION
01-02–207
01-02