Front Upper Arm Removal/Installation - Mazda MX-5 Miata Sport 2007 Manual

5. Measure the ball-joint rotational torque using an Allen wrench and a torque wrench.
Front upper arm ball joint rotational torque
0.3-2.2 N.m {4-22 kgf.cm, 3-19 in.lbf}
If not within the specification, replace the front upper arm. (See FRONT UPPER ARM

REMOVAL/INSTALLATION .)
Fig. 25: Measuring Ball-Joint Rotational Torque Using Allen Wrench & Torque Wrench
Courtesy of MAZDA MOTORS CORP.

FRONT UPPER ARM REMOVAL/INSTALLATION

CAUTION:
1. Remove in the order indicated in Fig. 26 .
2. Install in the reverse order of removal.
3. Inspect the front wheel alignment and adjust it if necessary. (See FRONT WHEEL ALIGNMENT .)
2007 Mazda MX-5 Miata Sport
2007 SUSPENSION Front Suspension - MX-5 Miata
Performing the following procedures without first removing the ABS

wheel-speed sensor may possibly cause an open circuit in the wiring
harness if it is pulled by mistake. Before performing the following
procedures, remove the ABS wheel-speed sensor (axle side) and fix
it to an appropriate place where the sensor will not be pulled while
servicing the vehicle.