Front Shock Absorber And Coil Spring - Mazda RX-8 Manual

FRONT SHOCK ABSORBER AND COIL SPRING

FRONT SHOCK ABSORBER AND COIL SPRING REMOVAL/INSTALLATION
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly
•
cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following
procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the
sensor will not be pulled while servicing the vehicle.
1. Remove the front suspension tower bar.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
1 Brake hose bracket
2 Front stabilizer control link
3 Front upper arm ball joint
4 Front shock absorber and coil spring
5 Piston rod nut
6 Retainer
7 Bushing
(w) RX-8 Suspension
Page 2