Table of Contents
Advertisement
no sflow rate [input | output]
7. Configure the sFlow statistic sampling interval
Command
Port Mode
sflow counter-interval <interval-vlaue>
no sflow counter-interval
8.
Configure the analyzer used by sFlow
Command
Global Mode
sflow analyzer sflowtrend
no sflow analyzer sflowtrend
59.3 sFlow Examples
As shown in the figure, sFlow sampling is enabled on the port 1/1 and 1/2 of the switch. Assume the sFlow
analysis software is installed on the PC with the address of 192.168.1.200. The address of the layer 3
interface on the SwitchA connected with PC is 192.168.1.100. A loopback interface with the address of
10.1.144.2 is configured on the SwitchA. sFlow configuration is as follows:
Configuration procedure is as follows:
Switch#config
Switch (config)#sflow ageng-address 10.1.144.2
Switch (config)#sflow destination 192.168.1.200
Switch (config)#sflow priority 1
Switch (config)# interface ethernet1/1
Switch (Config-If-Ethernet1/1)#sflow rate input 10000
SWITCH
Figure 59-1: sFlow configuration topology
command deletes the rate value.
Explanation
Configure the max interval when sFlow
performing statistic sampling. The "no" form of
this command deletes
Explanation
Configure the analyzer used by sFlow, the no
command deletes the analyzer.
59-37
PC
Advertisement
Table of Contents
Troubleshooting
