Planet WGSW-52040 Configuration Manual page 500

2. Configure the log host output channel
3. Enable/disable the log executed-commands
4. Display the log source
5. Display executed-commands state
1. Display and clear log buffer zone
Command
Admin Mode
show logging buffered [ level {critical |
warnings} | range <begin-index> <end-index>]
clear logging sdram
2. Configure the log host output channel
Command
Global Mode
logging {<ipv4-addr> | <ipv6-addr>} [ facility
<local-number> ] [level <severity>]
no logging {<ipv4-addr> | <ipv6-addr>} [ facility
<local-number>]
logging loghost sequence-number
no logging loghost sequence-number
3. Enable/disable the log executed-commands
Command
Global mode
logging executed-commands {enable | disable}
4. Display the log source
Command
Admin and configuration mode
Description
Show detailed log information in
the log buffer channel.
Clear log buffer zone information.
Description
Enable the output channel of the
log host. The "no" form of this
command will disable the output at
the output channel of the log host.
Add the loghost sequence-number
for the log, the no command does
not include the loghost
sequence-number.
Description
Enable or disable the logging
executed-commands
Description
66-71