Mld Snooping Troubleshooting - Planet WGSW-52040 Configuration Manual

48-port 10/100/1000base-t + 4-port 100/1000x sfp managed switch

Hide thumbs Also See for WGSW-52040:

Table of Contents

SwitchB#config

SwitchB(config)#ipv6 mld snooping

SwitchB(config)#ipv6 mld snooping vlan 100

SwitchB(config)#ipv6 mld snooping vlan 100 mrouter interface ethernet 1/1

Multicast configuration:

Same as scenario 1

MLD Snooping interception results:

Same as scenario 1

39.1.4 MLD Snooping Troubleshooting

In configuring and using MLD Snooping, the MLD Snooping server may fail to run properly due

to physical connection failure, wrong configuration, etc. The user should ensure the following:

Ensure the physical connection is correct

Ensure the MLD Snooping is enabled under global mode (using ipv6 mld snooping)

Ensure the MLD Snooping is configured on the vlan under global mode (using ipv6

mld snooping vlan <vlan-id>）

Ensure there is a vlan configured as a L2 general querier, or there is a static mrouter

configured in a segment,

Use command to check if the MLD snooping information is correct