Table of Contents
Advertisement
4. Configure the violation mode of ports
5. Display and debug the relative information of number limitation of MAC and IP on ports
1. Enable the number limitation function of MAC and IP on ports
Command
Port configuration mode
switchport mac-address dynamic
maximum <value>
no switchport mac-address dynamic
maximum
switchport arp dynamic maximum <value>
no switchport arp dynamic maximum
switchport nd dynamic maximum <value>
no switchport nd dynamic maximum
2. Enable the number limitation function of MAC and IP in VLAN
Command
VLAN configuration mode
vlan mac-address dynamic maximum
<value>
no vlan mac-address dynamic maximum
Interface configuration mode
ip arp dynamic maximum <value>
no ip arp dynamic maximum
ipv6 nd dynamic maximum <value>
no ipv6 nd dynamic maximum
3. Configure the timeout value of querying dynamic MAC
Command
Global configuration mode
mac-address query timeout <seconds>
4. Configure the violation mode of ports
Explanation
Enable and disable the number limitation
function of MAC on the ports.
Enable and disable the number limitation
function of ARP on the ports.
Enable and disable the number limitation
function of ND on the ports.
Explanation
Enable and disable the number limitation
function of MAC in the VLAN.
Enable and disable the number limitation
function of ARP in the VLAN.
Enable and disable the number limitation
function of NEIGHBOR in the VLAN.
Explanation
Configure the timeout value of querying
dynamic MAC.
43-160
Advertisement
Table of Contents
Troubleshooting
