Planet WGSW-52040 Configuration Manual page 103

decides the working mode and rate of the ports, ULDP won't take effect no matter
enabled or not. In such situation, the port is considered as "Down".
 In order to make sure that neighbors can be correctly created and unidirectional links can
be correctly discovered, it is required that both end of the link should enable ULDP, using
the same authentication method and password. At present, no password is needed on
both ends.
The hello interval of sending hello messages can be changed (it is10 seconds by default

and ranges from 5 to 100 seconds) so that ULDP can respond faster to connection errors
of links in different network environments. But this interval should be less than 1/3 of the
STP convergence time. If the interval is too long, a STP loop will be generated before
ULDP discovers and shuts down the unidirectional connection port. If the interval is too
short, the network burden on the port will be increased, which means a reduced
bandwidth.
 ULDP does not handle any LACP event. It treats every link of TRUNK group (like
Port-channel, TRUNK ports) as independent, and handles each of them respectively.
 ULDP does not compact with similar protocols of other vendors, which means users can
not use ULDP on one end and use other similar protocols on the other end.
 ULDP function is disabled by default. After globally enabling ULDP function, the debug
switch can be enabled simultaneously to check the debug information. There are several
DEBUG commands provided to print debug information, such as information of events,
state machine, errors and messages. Different types of message information can also be
printed according to different parameters.
 The Recovery timer is disabled by default and will only be enabled when the users have
configured recovery time (30-86400 seconds).
 Reset command and reset mechanism can only reset the ports automatically shut down
by ULDP. The ports shut down manually by users or by other modules won't be reset by
ULDP.
10-25