Planet WGSW-52040 Configuration Manual page 59

snmp-server securityip enable
snmp-server securityip disable
4. Configure engine ID
Command
Global Mode
snmp-server engineid <engine-string>
no snmp-server engineid
5. Configure user
Command
Global Mode
snmp-server user <use-string>
<group-string> [{authPriv | authNoPriv}
auth {md5 | sha} <word>] [access
{<num-std>|<name>}] [ipv6-access
{<ipv6-num-std>|<ipv6-name>}]
no snmp-server user <user-string>
[access {<num-std>|<name>}]
[ipv6-access
{<ipv6-num-std>|<ipv6-name>}]
6. Configure group
Command
Global Mode
snmp-server group <group-string>
{noauthnopriv|authnopriv|authpriv} [[read
<read-string>] [write <write-string>] [notify
<notify-string>]] [access
{<num-std>|<name>}] [ipv6-access
{<ipv6-num-std>|<ipv6-name>}]
no snmp-server group <group-string>
{noauthnopriv|authnopriv|authpriv}
[access {<num-std>|<name>}]
[ipv6-access
Enable or disable secure IP address check
function on the NMS.
Explanation
Configure the local engine ID on the switch.
This command is used for SNMP v3.
Explanation
Add a user to a SNMP group. This command
is used to configure USM for SNMP v3.
Explanation
Set the group information on the switch. This
command is used to configure VACM for
SNMP v3.
4-12