Table of Contents
Advertisement
Switch2(Config-If-Port-Channel2)#
Configuration result:
Shell prompts ports aggregated successfully after a while, now ports 1, 2, 3, 4 of S1 form an
aggregated port named "Port-Channel1", ports 6, 8, 9, 10 of S2 form an aggregated port
named "Port-Channel2"; can be configured in their respective aggregated port mode.
Scenario 2: Configuring Port Channel in ON mode.
As shown in the figure, ports 1, 2, 3, 4 of S1 are access ports and add them to group1 with "on"
mode. Ports 6, 8, 9, 10 of S2 are access ports and add them to group2 with "on" mode.
The configuration steps are listed below:
Switch1#config
Switch1(config)#interface ethernet 1/1
Switch1(Config-If-Ethernet1/1)#port-group 1 mode on
Switch1(Config-If-Ethernet1/1)#exit
Switch1(config)#interface ethernet 1/2
Switch1 (Config-If-Ethernet1/2)#port-group 1 mode on
Switch1 (Config-If-Ethernet1/2)#exit
Switch1 (config)#interface ethernet 1/3
Switch1 (Config-If-Ethernet1/3)#port-group 1 mode on
Switch1 (Config-If-Ethernet1/3)#exit
Switch1 (config)#interface ethernet 1/4
Switch1 (Config-If-Ethernet1/4)#port-group 1 mode on
Switch1 (Config-If-Ethernet1/4)#exit
Figure 12-3: Configure Port Channel in ON mode
S1
S2
12-38
Advertisement
Table of Contents
Troubleshooting
