Planet WGSW-52040 Configuration Manual page 314

[no] access-list <5000-5099>
{deny|permit} ip {{<source>
<source-wildcard>}|{host-source
<source-host-ip>}|any-source}
{{<destination>
<destination-wildcard>}|{host-desti
nation
<destination-host-ip>}|any-destinat
ion}
The last is to configure the configured rule to specified port.
Note: If the rules being configured will occupy the table entries of hardware, configuring too
many rules will result in configuration failure caused by bottom table entries being full, so we
suggest user to use the simplest rules if possible. The configuration rules are as follows:
Command
Port Configuration Mode
[no] ip multicast source-control
access-group <5000-5099>
2． Destination Control Configuration
Like source control configuration, destination control configuration also has three steps.
First, enable destination control globally. Since destination control need to prevent
unauthorized user from receiving multicast data, the switch won't broadcast the multicast data
it received after configuring global destination control. Therefore, It should be avoided to
connect two or more other Layer 3 switches in the same VLAN on a switch on which
destination control is enabled. The configuration commands are as follows:
Command
Global Configuration Mode
[no] multicast destination-control
（required）
The rule used to configure source control. This
rule does not take effect until it is applied to
specified port. Using the NO form of it can delete
specified rule.
Explanation
Used to configure the rules source control uses
to port, the NO form cancels the configuration.
Explanation
Globally enable destination control.
The no operation of this command will
globally disable destination control. All
of the other configuration can only
take effect after globally enabled. The
next is configuring destination control
rules, which are similar.
38-93