Planet WGSW-52040 Configuration Manual page 71

Figure 4-2 Download nos.img file as FTP/TFTP client
Scenario 1: The switch is used as FTP/TFTP client. The switch connects from one of its ports
to a computer, which is a FTP/TFTP server with an IP address of 10.1.1.1; the switch acts as a
FTP/TFTP client, the IP address of the switch management VLAN is 10.1.1.2. Download
"nos.img" file in the computer to the switch.
FTP Configuration

Computer side configuration:
Start the FTP server software on the computer and set the username "Switch", and the
password "superuser". Place the "12_30_nos.img" file to the appropriate FTP server directory
on the computer.
The configuration procedures of the switch are listed below:
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip address 10.1.1.2 255.255.255.0
Switch(Config-if-Vlan1)#no shut
Switch(Config-if-Vlan1)#exit
Switch(config)#exit
Switch#copy ftp: //Switch:switch@10.1.1.1/12_30_nos.img nos.img
With the above commands, the switch will have the "nos.img" file in the computer downloaded
to the FLASH.
TFTP Configuration

Computer side configuration:
Start TFTP server software on the computer and place the "12_30_nos.img" file to the
appropriate TFTP server directory on the computer.
The configuration procedures of the switch are listed below:
10.1.1.2
10.1.1.1
4-24