Table of Contents
Advertisement
Admin mode
clear vacl [in | out] statistic vlan
[<vlan-id>]
53.3 VLAN-ACL Configuration Example
A company's network configuration is as follows, all departments are divided by different VLANs, technique
department is Vlan1, finance department is Vlan2. It is required that technique department can access the
outside network at timeout, but finance department are not allowed to access the outside network at any time
for the security. Then the following policies are configured:
Set the policy VACL_A for technique department. At timeout they can access the outside network, the
rule as permit, but other times the rule as deny, and the policy is applied to Vlan1.
Set the policy VACL_B of ACL for finance department. At any time they can not access the outside
network, but can access the inside network with no limitation, and apply the policy to Vlan2.
Network environment is shown as below:
Configuration example:
1) First, configure a timerange, the valid time is the working hours of working day:
Switch(config)#time-range t1
Switch(config-time-range-t1)#periodic weekdays 9:00:00 to 12:00:00
Figure 53-1: VLAN-ACL configuration example
53-3
Clear the statistic information of VACL.
(Egress filtering is not supported by
switch.)
Advertisement
Table of Contents
Troubleshooting
