Table of Contents
Advertisement
3. Virtual cable test
Command
Admin Mode
virtual-cable-test interface ethernet
<interface-list>
7.3 Port Configuration Example
Switch 1
1/7
Switch 3
No VLAN has been configured in the switches, default VLAN1 is used.
Switch
Switch1
Switch2
Switch3
The configurations are listed below:
Switch1:
Switch1(config)#interface ethernet 1/7
Switch1(Config-If-Ethernet1/7)#bandwidth control 50000 receive
1/12
Figure 7-1: Port Configuration Example
Port
1/7
1/8
1/9
1/10
1/12
Explanation
Test virtual cables of the port.
1/9
1/8
Switch 2
Property
Ingress bandwidth limit: 50 M
Mirror source port
100Mbps full, mirror source port
1000Mbps full, mirror destination port
100Mbps full
7-11
1/10
Advertisement
Table of Contents
Troubleshooting
