Debug; System Log; System Log Introduction - Planet WGSW-52040 Configuration Manual

show startup-config
show switchport interface [ethernet
<IFNAME>]
show tcp
show tcp ipv6
show udp
show udp ipv6
show telnet login
show tech-support
show version
show temperature
show fan

66.6 Debug

All the protocols switch supports have their corresponding debug commands. The users can use the
information from debug commands for troubleshooting. Debug commands for their corresponding protocols
will be introduced in the later chapters.

66.7 System log

66.7.1 System Log Introduction

The system log takes all information output under it control, while making detailed catalogue, so to select the
information effectively. Combining with Debug programs, it will provide a powerful support to the network
administrator and developer in monitoring the network operation state and locating the network failures.
The switch system log has following characteristics
 Log output from four directions (or log channels) of the Console, Telnet terminal and monitor, log buffer
Display the switch parameter configuration
written in the Flash Memory at current operation
state, which is normally the configuration file
applied in next time the switch starts up.
Display the VLAN port mode and the belonging
VLAN number of the switch as well as the Trunk
port information.
Display the TCP connection status established
currently on the switch.
Display the UDP connection status established
currently on the switch.
Display the information of the Telnet client which
currently establishes a Telnet connection with
the switch.
Display the operation information and the state
of each task running on the switch. It is used by
the technicians to diagnose whether the switch
operates properly.
Display the version of the switch.
This command is not supported by switch.
This command is not supported by switch.
66-68