Option 82 Working Mechanism - Planet WGSW-52040 Configuration Manual

SubOpt: the sequence number of sub-option, the sequence number of Circuit ID sub-option is
1, the sequence number of Remote ID sub-option is 2.
Len: the number of bytes in Sub-option Value, not including the two bytes in SubOpt segment
and Len segment.

33.1.2 Option 82 Working Mechanism

DHCP Relay Agent
DHCP Request DHCP Request Option82
DHCP Reply
DHCP Reply
Option82
DHCP Client
DHCP Server
DHCP option 82 flow chart
If the DHCP Relay Agent supports option 82, the DHCP client should go through the following
four steps to get its IP address from the DHCP server: discover, offer, select and acknowledge.
The DHCP protocol follows the procedure below:
1）DHCP client sends a request broadcast message while initializing. This request message
does not have option 82.
2） DHCP Relay Agent will add the option 82 to the end of the request message it receives, then
relay and forward the message to the DHCP server. By default, the sub-option 1 of option 82
(Circuit ID) is the interface information of the switch connected to the DHCP client (VLAN
name and physical port name), but the users can configure the Circuit ID as they wish. The
sub-option 2 of option 82(Remote ID) is the MAC address of the DHCP relay device.
3）After receiving the DHCP request message, the DHCP server will allocate IP address and
33-53