Table of Contents
Advertisement
Removing the transceiver module
1．
Make sure there is no network activity by checking with the network administrator, or through the management
interface of the switch/converter (if available) to disable the port in advance.
2．
Remove the Fiber Optic Cable gently.
3．
Lift up the lever of the MGB module and turn it to a horizontal position.
4．
Pull out the module gently through the lever.
Never pull out the module without lifting up the lever of the module and turning it to
a horizontal position. Directly pulling out the module could damage the module and
the SFP module slot of the Managed Switch.
Figure 2-8 Pull out the SFP transceiver
2-9
Advertisement
Table of Contents
Troubleshooting
