System Log Configuration Example - Planet WGSW-52040 Configuration Manual

show logging source mstp
5. Display executed-commands state
Command
Admin mode
show logging executed-commands state

66.7.3 System Log Configuration Example

Example 1: When managing VLAN the IPv4 address of the switch is 100.100.100.1, and the IPv4 address of
the remote log server is 100.100.100.5. It is required to send the log information with a severity equal to or
higher than warnings to this log server and save in the log record equipment local1.
Configuration procedure:
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)# ip address 100.100.100.1 255.255.255.0
Switch(Config-if-Vlan1)#exit
Switch(config)#logging 100.100.100.5 facility local1 level warnings
Example 2: When managing VLAN the IPv6 address of the switch is 3ffe:506::1, and the IPv4 address of the
remote log server is 3ffe:506::4. It is required to send the log information with a severity equal to or higher
than critical to this log server and save the log in the record equipment local7.
Configuration procedure
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 address 3ffe:506::1/64
Switch(Config-if-Vlan1)#exit
Switch(config)#logging 3ffe:506::4 facility local7 level critical
Show the log information source of
MSTP module.
Description
Show the state of logging
executed-commands
66-72