Table of Contents
Advertisement
1. Enter the Ethernet port configuration mode
Command
Global Mode
interface ethernet <interface-list>
2. Configure the properties for the Ethernet ports
Command
Port Mode
media-type {copper |
copper-preferred-auto | fiber |
sfp-preferred-auto}
shutdown
no shutdown
description <string>
no description
mdi {auto | across | normal}
no mdi
speed-duplex {auto [10 [100 [1000]]
[auto | full | half |]] | force10-half |
force10-full | force100-half |
force100-full | force100-fx
[module-type {auto-detected |
no-phy-integrated | phy-integrated}] |
{{force1g-half | force1g-full}
[nonegotiate [master | slave]]}|
force10g-full}
no speed-duplex
negotiation {on|off}
bandwidth control <bandwidth> [both |
receive | transmit]
no bandwidth control
flow control
no flow control
Explanation
Enters the network port configuration mode.
Explanation
Sets the combo port mode (combo ports
only).
Enables/Disables specified ports.
Specifies or cancels the name of specified
ports.
Sets the cable type for the specified port; this
command is not supported by combo port
and fiber port of switch.
Sets port speed and duplex mode of
100/1000Base-TX or 100Base-FX ports. The
no format of this command restores the
default setting, i.e., negotiates speed and
duplex mode automatically.
Enables/Disables the auto-negotiation
function of 1000Base-FX ports.
Sets or cancels the bandwidth used for
incoming/outgoing traffic for specified ports.
Enables/Disables traffic control function for
specified ports.
7-9
Advertisement
Table of Contents
Troubleshooting
