Table of Contents
Advertisement
20.7.3 Example of GVRP
GVRP application:
To enable dynamic VLAN information register and update among switches, GVRP protocol is
to be configured in the switch. Configure GVRP in Switch A, B and C, enable Switch B to learn
VLAN100 dynamically so that two workstations connected to VLAN100 in Switch A and C can
communicate with each other through Switch B without static VLAN100 entries.
Configuration
Configuration description
Item
VLAN100
Port 2-6 of Switch A and C.
Trunk port
Port 11 of Switch A and C, Port 10, 11 of Switch B.
Global GVRP
Switch A, B, C.
Port GVRP
Port 11 of Switch A and C, Port 10, 11 of Switch B.
Connect two workstations to the VLAN100 ports in switch A and B, connect port 11 of Switch A
to port 10 of Switch B, and port 11 of Switch B to port 11 of Switch C.
The configuration steps are listed below:
PC
Switch A
Switch C
PC
Figure 20-11: Typical GVRP Application Topology
20-100
Switch B
Advertisement
Table of Contents
Troubleshooting
