Table of Contents
Advertisement
low-warn} {<value> | default}}
3. Configure the state of the transceiver monitoring
(1) Configure the interval of the transceiver monitoring
Command
Global mode
transceiver-monitoring interval <minutes>
no transceiver-monitoring interval
（2）Configure the enable state of the transceiver monitoring
Command
Port mode
transceiver-monitoring {enable | disable}
（3）Show the information of the transceiver monitoring
Command
Admin mode and global mode
show transceiver threshold-violation
[interface ethernet <interface-list>]
Explanation
Set the interval of the transceiver
monitor. The no command sets the
interval to be the default interval of
15 minutes.
Explanation
Set whether the transceiver
monitoring is enabled. Only the port
enables the transceiver monitoring,
the system records the abnormity
state. After the port disables the
function, the abnormity information
will be clear.
Explanation
Show the information of the
transceiver monitoring, including the
last threshold-violation informatijon,
the interval of the current transceiver
monitoring and whether the port
enables the transceiver monitoring.
16-55
Advertisement
Table of Contents
Troubleshooting
