Planet WGSW-52040 Configuration Manual page 36

48-port 10/100/1000base-t + 4-port 100/1000x sfp managed switch

Hide thumbs Also See for WGSW-52040:

Table of Contents

3) In the "Connect using" drop-list, select the RS-232 serial port used by the PC, e.g. COM1, and click "OK".

4) COM1 property appears, select "9600" for "Baud rate", "8" for "Data bits", "none" for "Parity checksum", "1"

for stop bit and "none" for traffic control; or, you can also click "Restore default" and click "OK".

Figure 3-4 Opening HyperTerminal

Figure 3-5 Opening HyperTerminal

Troubleshooting