Table of Contents
Advertisement
Command
Port Mode
dot1x port-method {macbased |
portbased | userbased {standard |
advanced}}
no dot1x port-method
dot1x max-user macbased <number>
no dot1x max-user macbased
dot1x max-user userbased <number>
no dot1x max-user userbased
dot1x guest-vlan <vlanID>
no dot1x guest-vlan
dot1x portbased mode single-mode
no dot1x portbased mode single-mode
3) Configure expanded 802.1x function
Command
Global Mode
dot1x macfilter enable
no dot1x macfilter enable
dot1x macbased
port-down-flush
no dot1x macbased
port-down-flush
Explanation
Sets the port access management method;
the no command restores MAC-based
access management.
Sets the maximum number of access users
for the specified port; the no command
restores the default setting of allowing 1
user.
Set the upper limit of the number of users
allowed accessing the specified port, only
used when the access control mode of the
port is userbased; the no command is used
to reset the limit to 10 by default.
Set the guest vlan of the specified port; the
no command is used to delete the guest
vlan.
Set the single-mode based on portbase
authentication mode; the no command
disables this function.
Explanation
Enables the 802.1x address filter function in the switch; the
no command disables the 802.1x address filter function.
Enables this command, when the dot1x certification
according to mac is down, delete the user who passed the
certification of the port; The no command does not make
the down operation.
42-150
Advertisement
Table of Contents
Troubleshooting
