Planet WGSW-52040 Configuration Manual page 315

48-port 10/100/1000base-t + 4-port 100/1000x sfp managed switch
Hide thumbs Also See for WGSW-52040:
Table of Contents

Advertisement

Next is to configure destination control rule. It is similar to source control, except to use ACL
No. of 6000-7999.
Command
Global Configuration Mode
[no] access-list <6000-7999> {deny|permit} ip
{{<source> <source-wildcard>}|{host-source
<source-host-ip>{range<2-65535>|}}|any-sou
rce} {{<destination>
<destination-wildcard>}|{host-destination
<destination-host-ip>{range<2-255>|}}|any-d
estination}
The last is to configure the rule to specified source IP, source VLAN MAC or specified port. It is
noticeable that, due to the above situations, these rules can only be used globally in enabling
IGMP-SNOOPING. And if IGMP-SNOOPING is not enabled, then only source IP rule can be
used under IGMP Protocol. The configuration commands are as follows:
Command
Port Configuration Mode
[no] ip multicast destination-control
access-group <6000-7999>
Global Configuration Mode
[no] ip multicast destination-control
<1-4094> <macaddr> access-group
<6000-7999>
[no] ip multicast destination-control
<IPADDRESS/M> access-group
<6000-7999>
3. Multicast Strategy Configuration
Multicast Strategy uses the manner of specifying priority for specified multicast data to achieve
and guarantee the effects the specific user requires. It is noticeable that multicast data can not
get a special care all along unless the data are transmitted at TRUNK port. The configuration is
very simple, it has only one command, i.e. to set priority for the specified multicast. The
Explanation
The rule used to configure destination
control. This rule does not take effect
until it is applied to source IP or
VLAN-MAC and port. Using the NO
form of it can delete specified rule.
Explanation
Used to configure the rules destination
control uses to port, the NO form
cancels the configuration.
Used to configure the rules destination
control uses to specify VLAN-MAC, the
NO form cancels the configuration.
Used to configure the rules destination
control uses to specified IP address/net
mask, the NO form cancels the
configuration.
38-94

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents