Planet WGSW-52040 Configuration Manual page 191

switchport port-security lock
no switchport port-security lock
switchport port-security convert
switchport port-security timeout <value>
no switchport port-security timeout
switchport port-security mac-address
<mac-address>
no switchport port-security
mac-address <mac-address>
Admin Mode
clear port-security dynamic [address
<mac-addr> | interface <interface-id>]
3. MAC address binding property configuration
Command
Port Mode
switchport port-security maximum
<value>
no switchport port-security maximum
<value>
switchport port-security violation
{protect | shutdown} [recovery
<30-3600>]
no switchport port-security violation
21.5.1.3 Binding MAC Address Binding Troubleshooting
Enabling MAC address binding for ports may fail in some occasions. Here are some possible
causes and solutions:
Lock the port, then MAC addresses
learned will be disabled. The "no
switchport port-security lock" command
restores the function. Notice: This
command is not supported by the switch.
Convert dynamic secure MAC addresses
learned by the port to static secure MAC
addresses. Notice: This command is not
supported by the switch.
Enable port locking timer function; the "no
switchport port-security timeout"
restores the default setting. Notice: This
command is not supported by the switch.
Add static secure MAC address;
switchport port-security mac-address"
command deletes static secure MAC
address.
Clear dynamic MAC addresses learned by
the specified port.
Explanation
Set the maximum number of secure MAC
addresses for a port; the "no switchport
port-security maximum" command
restores the default value.
Set the violation mode for the port; the "no
switchport port-security violation"
command restores the default setting.
21-113
the "no