Dcscm Configuration Task List - Planet WGSW-52040 Configuration Manual

The Service-Oriented Priority Strategy Multicast of Security Controllable technology adopts the
following mode: for multicast data in limit range, set the priority specified by the user at the
join-in end so that data can be sent in a higher priority on TRUNK port, consequently
guarantee the transmission is processed in user-specified priority in the entire network.

38.2.2 DCSCM Configuration Task List

1． Source Control Configuration
2． Destination Control Configuration
3． Multicast Strategy Configuration
1． Source Control Configuration
Source Control Configuration has three parts, of which the first is to enable source control. The
command of source control is as follows:
Command
Global Configuration Mode
[no] ip multicast source-control
(Required)
The next is to configure the rule of source control. It is configured in the same manner as for
ACL, and uses ACL number of 5000-5099, every rule number can be used to configure 10
rules. It is noticeable that these rules are ordered, the front one is the one which is configured
the earliest. Once the configured rules are matched, the following rules won't take effect, so
rules of globally allow must be put at the end. The commands are as follows:
Command
Global Configuration Mode
Explanation
Enable source control globally, the "no ip
multicast source-control" command disables
source control globally. It is noticeable that, after
enabling source control globally, all multicast
packets are discarded by default. All source
control configuration can not be processed until
that it is enabled globally, while source control
can not be disabled until all configured rules are
disabled.
Explanation
38-92