Efm Oam Configuration - Planet WGSW-52040 Configuration Manual

Typical EFM OAM application topology is in the following, it is used for point-to-point link and
emulational IEEE 802.3 point-to-point link. Device enables EFM OAM through point-to-point
connection to monitor the link fault in the First Mile with Ethernet access. For user, the
connection between user to telecommunication is "the First Mile", for service provider, it is "the
Last Mile".
Customer
802.3ah
Ethernet in
the First Mile

14.2 EFM OAM Configuration

EFM OAM configuration task list
1. Enable EFM OAM function of port
2. Configure link monitor
3. Configure remote failure
Note: it needs to enable OAM first when configuring OAM parameters.
1. Enable EFM OAM function of port
Command
Port mode
ethernet-oam mode {active | passive}
ethernet-oam
no ethernet-oam
Service Provider
CE
802.1ah OAMPDU
Figure 14-2: Typical OAM application topology
14-44
PE
Explanation
Configure work mode of EFM OAM,
default is active mode.
Enable EFM OAM of port, no
command disables EFM OAM of
port.
Customer