Port Loopback Detection Function Example - Planet WGSW-52040 Configuration Manual

Command
Admin Mode
debug loopback-detection
no debug loopback-detection
show loopback-detection [interface
<interface-list>]
5. Configure the loopback-detection control mode (automatic recovery enabled or not)
Command
Global Mode
loopback-detection control-recovery
timeout <0-3600>

9.3 Port Loopback Detection Function Example

Figure 9-1: Typical example of port loopback detection
Explanation
Enable the debug information of the
function module of port loopback detection.
The no operation of this command will
disable the debug information.
Display the state and result of the loopback
detection of all ports, if no parameter is
provided; otherwise, display the state and
result of the corresponding ports.
Explanation
Configure the loopback-detection control
mode (automatic recovery enabled or not)
or recovery time.
SWITCH
Network Topology
9-17